Skip to main content

Collector Knowledge base

Collector installation instructions and device specifications. 

Pinned articles

Get started

It can easily feel overwhelming to figure out how to get started with TestLogger Collector, but we are here to help you. Collector has quite a few things to ...

Documentation

Get started

It can easily feel overwhelming to figure out how to get started with TestLogger Collector, but we are here to help you. Collector has quite a few things to ...

Main units

Main units works as the core unit for data logging. Collector Mini

Sensors

Sensors are used to log the data from the car and each sensor has some specific instructions how to install and configure it. Please find TL0103003 - Tempera...

Cables

TestLogger Collector uses few different types of cables which are introduced on this page. Currently we offer cables as follows. Receiver cables 3-pin cable ...

Measured channels

Collector Mini allows to measure variety of channels for performance analysis, but many of the measured values provides possiblities to calculate more releva...

Frequently asked questions

How to check magnet polarity? Before installing the speed sensor or magnets in to the car, it's best to check polarity on the table. Here is some steps how t...

Sensor brackets

We have designed few brackets for Collector sensors and we share those in public Github repository at https://github.com/testlogger/tl-collector-3d-print-fil...

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.